Mountaineer 4WD V6-4.0L VIN E (1999)
6. Remove the driveshaft flange yoke.
1
Position the driveshaft flange yoke in the U-Joint Tool.
2
Press out a bearing cup.
3
Remove the driveshaft flange yoke.
4
Press on the spider to remove the remaining bearing cup.
5
Remove the driveshaft flange yoke.
7. Remove the spider.
1
Reposition the driveshaft in the U-Joint Tool. Press out the bearing cup. Rotate the driveshaft. Press on the spider to remove the remaining
bearing cup. Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
Assembly
1. NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix components from other U-joint kits.
Install the spider.
1
Start a new bearing cup into the driveshaft yoke.
-
Check the needle bearings for correct positioning.
2
Position the new spider in the driveshaft yoke.
3
Position the driveshaft in the U-Joint Tool.
4
Press the bearing cup to just below the snap ring groove.
5
Repeat for the other bearing cup.
2. Inspect the driveshaft flange yoke. Install new if necessary.
