Mountaineer 4WD V6-4.0L VIN E (1999)
Installation
1. NOTE: Axle tube bushing installation shown, axle housing bushing is a similar procedure.
Position the tube bushing and the tube bushing installation tools.
1
Position the tube bushing.
2
Position the Gauge Ring.
3
Position the Bushing Replacer Collet.
4
Position the Bushing Remover/Replacer Cup.
5
Position the Drawbolt.
6
Thread the Bushing Replacer Adapter on the Drawbolt.
2. Tighten the Drawbolt to install the tube bushing.
-
Remove the tools.
3. Install the front axle assembly.
4. Check the fluid level and fill the axle to specification.
-
Use Motorcraft SAE 80W90 Thermally Stable 4x4 Axle Lubricant meeting Ford specification WSP-M2C197-A.
5. Lower the vehicle.
6. If equipped with air suspension, reactivate the system by turning on the air suspension switch.
