Mountaineer 4WD V8-302 5.0L VIN P SFI (2000)
7. Connect the molded lead frame to the solenoids.
-
Connect the bulkhead inter-connector.
-
Connect the EPC solenoid.
-
Connect the TCC.
-
Connect the shift solenoid SSA and SSB.
8. CAUTION: If installing a new filter, and the grommet remains in the main control bore, carefully use a small screwdriver to remove the
grommet. Use care not to damage the main control bore.
Note: If transmission is being repaired liar a contamination-related failure, use a new filter and seal.
Replace fluid filter and seal as required.
9. Position the (B) pan magnet into the (A) transmission fluid pan.
10. Note: The pan gasket is reusable. Clean and inspect for damage; if not damaged, the gasket should be reused.
Install the transmission fluid pan.
1. Position the transmission fluid pan gasket.
2. Position the transmission fluid pan.
