Mountaineer AWD V6-4.0L (2008)
Antenna: Service and Repair
Antenna
ANTENNA
Removal and Installation
1. NOTE: To access the antenna cable-to-antenna lead-in cable connection, lower the glove compartment door.
Disconnect the antenna cable from the antenna lead-in cable and release the pin-type retainers.
2. Remove the RH cowl side trim panel and the RH front door scuff plate trim panel.
3. Remove the antenna mast and the antenna mast stanchion.
4. Remove the RH fender splash shield.
5. Release the antenna cable grommet.
6. Remove the antenna cable bracket bolt and the antenna cable assembly.
-
To install, tighten to 8 Nm (71 lb-in).
7. To install, reverse the removal procedure.
