Mountaineer AWD V6-4.0L (2008)
Air Door Actuator / Motor: Service and Repair
Vacuum Control Motor - Defroster Door
VACUUM CONTROL MOTOR - DEFROSTER DOOR
Removal and Installation
1. Remove the audio control module (ACM).
2. Remove the lower steering column cover.
3. Remove the 3 center panel duct screws and position the center panel duct aside.
4. Remove the 2 plenum chamber screws.
5. Disconnect the defrost door vacuum control motor vacuum connector.
6. Remove the 2 defrost door vacuum control motor screws.
7. NOTE: The plenum chamber must be slightly repositioned to allow the defrost door vacuum control motor to be rotated far enough to clear the