Mountaineer AWD V6-4.0L (2008)
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
^
Discard the bolts.
^
Support the caliper and anchor plate assembly using mechanic's wire.
^
To install, tighten to 165 Nm (122 lb-ft).
5. Remove the brake disc.
6. NOTE: A new wheel bearing and wheel hub comes with the wheel speed sensor installed.
Disconnect the wheel speed sensor harness electrical connector and remove and discard the wheel speed sensor harness bracket bolt.
^
To install, tighten to 8 Nm (71 lb-inch).
7. Remove the 3 bolts and the wheel bearing and hub assembly.
^
Discard the bolts.
^
To install, tighten to 122 Nm (90 lb-ft).
8. To install, reverse the removal procedure.
