Mountaineer AWD V6-4.0L (2008)
Fuel Temperature Sensor: Service and Repair
FUEL RAIL PRESSURE AND TEMPERATURE SENSOR
Removal and Installation
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
-
Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental
spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this
instruction may result in serious personal injury.
1. Release the fuel system pressure.
2. Remove the intake manifold.
3. Disconnect the fuel rail pressure and temperature sensor vacuum and electrical connectors.
4. Remove the bolts and the fuel rail pressure and temperature sensor.
-
To install, tighten to 6 Nm (53 lb-in).
5. Remove and discard the O-ring seal.
6. CAUTION:
-
Use an O-ring seal made of special fuel resistant material. Use of an ordinary O-ring seal may cause the fuel system to leak. Do not
reuse the O-ring seal.
-
Do not reuse the O-ring seal. Reusing an O-ring seal may cause the fuel system to leak.
