Mountaineer AWD V6-4.0L (2008)
(3)
Choose reset KAM.
(4)
Then choose TCM.
b.
Using PDS:
(1)
Choose all Tests and Calibrations.
(2)
Scroll down the menu and choose reset 1CM KAM.
NOTE
FOR PDS, RESET TCM KAM IS NOT THE SAME AS CLEAR TRANSMISSION ADAPTIVE TABLES, WHICH IS UNDER THE
POWERTRAIN - TRANSMISSION MENU TREE.
NOTE
UNHOOKING THE BATTERY WILL NOT CLEAR THE TCM KAM.
NOTE
DO NOT CLEAR THE PCM KAM.
4.
Verify that the transmission fluid temperature (TFT) PID is above 175 °F (80 °C). If it is not at 175 °F (80 °C), drive unit approximately 3 miles (5
Km) to reach temperature.
NOTE
TFT MUST BE AT 175 °F (80 °C) OR ABOVE BEFORE PROCEEDING TO STEP 5.
5.
Drive the unit to perform adaptive shift strategy learn.
a.
Accelerate from a stop with light throttle to 15 MPH (24 Km/h), remove foot from accelerator pedal.
b.
Brake very gently to a complete stop (allow at least six (6) seconds).
c.
Repeat steps (a-b) five (5) times in the dealership parking lot or similar setting.
d.
Accelerate from a stop with light throttle ensuring that the 1-2, 2-3 and 3-4 shifts occur at engine speeds between 1300-1800 RPM.
e.
Continue to accelerate until you achieve 50 MPH (80 Km/h) or the 5-6 upshift.
f.
Brake gently to a complete stop and hold foot on brake for 10 seconds.
g.
Repeat steps (e-f) three (3) times.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
081306A
2008 Expedition, Explorer,
1.0 Hr.
Mountaineer, Explorer
Sport Trac: Check DTCs,
Reprogram PCM/TCM,
Includes Time To Clear
TCM KAM, Raise Vehicle
To Verify Transmission
Serial Number And,
Perform Road Test (Do
Not Use With 12650D,
12651D, 12651D4)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
RECAL
04