Mountaineer AWD V6-4.0L (2008)
9. CAUTION: Do not touch the electrical connector pins or the exposed solenoid tabs on the transmission control module (TCM).
Electrostatic discharge may occur and may cause damage to the mechatronic unit.
Pull the bulkhead electrical connector out of the transmission.
10. NOTE: During removal of the mechatronic, the thermal bypass valve, pump adapter seal and one or more center support seals may become
dislodged. Save these components for re-use during assembly.
Remove the 11 bolts from the mechatronic assembly and remove the mechatronic assembly.
Installation
NOTE: Before reinstalling the mechatronic assembly into the transmission case, verify presence and correct orientation of the thermal bypass valve,
pump adapter seal and center support seals. Also note that one or more of the center support seals may have remained in the mechatronic assembly
during removal and should be installed into the transmission case at this time.
1. Verify the 4 rubber feed tubes for the center support are in place.
1
Black feed tube.
2
Green feed tube.
3
Blue feed tube.
