Mountaineer AWD V6-4.0L (2008)
Back Window Glass: Service and Repair
Window Glass - Rear, Power
WINDOW GLASS - REAR, POWER
Material
Material
Removal
NOTE:
-
The rear window regulator motor must be initialized when repairs are performed on any part of the power rear window system including when: the
power rear window motor is removed from the window regulator drum housing, a new power rear motor is installed, a new power rear window
regulator is installed, a new power rear window glass module is installed, and any operation in which grease or lubricants are applied to the power
rear window system.
-
If the rear window glass is being removed to repair a dust/water leak, remove and reinstall the existing rear window glass.
1. Remove the rear window glass regulator.
2. Remove both C-pillar upper trim panels.
3. Remove the 12 rear window glass mounting nuts.
4. CAUTION: Use only a plastic windshield setting tool to slide under the seal to separate the foam core butyl from the glass. Once the glass
starts to separate from the body, constant hand pressure will break the seal and the glass can be removed. Failure to use a plastic
windshield setting tool can damage the body or the glass frame.
