Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
Body / Frame Mount Bushing: Service and Repair
Body Support - Radiator Support
BODY SUPPORT - RADIATOR SUPPORT
Removal and Installation
Upper and Lower Insulator
NOTE: Left side shown, right side similar.
1. From inside the engine compartment, remove the body mount insulator nut and backing plate and discard the nut.
Lower Insulator
2. Remove the lower radiator body mount.
1. Remove the lower body mount bolt and discard.
2. Remove the lower body mount.
Upper and Lower Insulator
3. Carefully raise the vehicle body enough to remove the upper radiator body mount insulator.
4. NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body insulator installation.
To install, reverse the removal procedure.
