Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
7.
Install one (1) seat track clip as shown in (Figure 1) on the right side of track assembly. Position clip so the tabs are facing the front of the seat.
8.
Install the second seat track clip as shown in (Figure 2) on the left side of track assembly. Position clip so tabs are facing the front of the seat.
NOTE
MAKE SURE THE BATTERY NEGATIVE CABLE IS STILL DISCONNECTED BEFORE CONTINUING WITH THE REINSTALLATION
PORTION OF THIS PROCEDURE.
9.
Lower the seat and reconnect the seat electrical connectors.
10.
Position the seat and install the four (4) seat track mounting bolts. Torque to 30 lb-ft (40 N.m).
11.
Install the four (4) seat track bolt covers.
12.
Repower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in Workshop Manual Section 501-20B.
13.
Prove out the SRS before releasing the vehicle to the customer. Refer to Workshop Manual Section 501-20B.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
050416A
2002-2005
0.7 Hr.
Explorer/Mountaineer
2003-2005 Aviator: Install
Clips Into Seat Track
