Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
3. NOTE: The special tool must be installed on the damper and should contact the engine block, this positions the piston at TDC.
Install the special tools.
4. Install the special tools on the rear of the RH cylinder head and tighten the top two clamp bolts to 10 Nm (89 inch lbs.)
5. CAUTION: The RH camshaft sprocket is a LH threaded bolt.
Using the special tool, loosen the camshaft sprocket bolt.
6. Remove the special tools.
