mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Air Bag Disarming and Arming|Page 8028 > < Air Bag Disarming and Arming|Page 8026
Page 24
background image

Connect the battery ground cable.

24. Prove out the supplemental restraint system (SRS) as follows:

Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an air bag supplemental restraint
system (SRS) fault is present, the air bag indicator will either:
-

fail to light.

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed
and repaired.

Clear all continuous DTCs from the restraints control module using a scan tool.

Vehicles with safety canopies

25. Check the active restraints for correct operation.

Deactivation

Special Tool(s)

Special Tool(s) 

Deactivation 

WARNING:  Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air
bag module. This will reduce the risk of injury in the event of an accidental deployment.
 

WARNING:  Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in
the event of an accidental deployment.
 

Air Bag Disarming and Arming|Page 8028 > < Air Bag Disarming and Arming|Page 8026