mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Driver Air Bag Module|Page 8069 > < Driver Air Bag Module|Page 8067
Page 8
background image

Part 2

4. CAUTION:  The safety canopy retainers must always be tightened starting in the middle and work out from there.

Install the components in the order indicated in the illustration and table.

5. Connect the battery ground cable.
6. With the restraint system diagnostic tools still installed at the remaining deployable devices, prove out the supplemental restraint system (SRS).  

See: Air Bag(s) Arming and Disarming/Service and Repair/Prove Out Procedure

7. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

The side impact sensors (if equipped) are located at or near the base of the B-pillars and C-pillars.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable and wait at least one minute.

8. WARNING:  Anytime the safety canopy has deployed, the headliner, and all A, B, and C pillar upper trim panels and attaching

hardware must be replaced along with any other damaged components and hardware. Failure to do so may result in personal injury in
the event of a safety canopy deployment.

Install the headliner.

9. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, notes, and instructions in the supplemental

restraint system (SRS) deactivation/reactivation procedure.

Reactivate the supplemental restraint system (SRS).

10. Connect the battery ground cable.

11. WARNING:  The restraint system diagnostic tool is for restraint system service only. Remove from the vehicle prior to road use. Failure

to remove could result in injury and possible violation of vehicle safety standards.

With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).  See: Air Bag(s) Arming and
Disarming/Service and Repair/Prove Out Procedure

Driver Air Bag Module|Page 8069 > < Driver Air Bag Module|Page 8067