Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
Item 7: Rear Stub Shaft Housing Bearing and Seal Installation Note
1. Lubricate the stub shaft housing bearing with axle lubricant. Place the stub shaft housing bearing on the special tool.
2. Install the stub shaft housing axle housing bore.
3. Lubricate the lips of the stub shaft housing bearing seal with rear axle lubricant. Place the seal on the special tool.
4. CAUTION: Installation of the stub shaft housing bearing and seal without the correct tool can result in an early bearing or seal failure. If the
bearing or seal become cocked during installation, remove it and install a new one.
Carefully align the stub shaft housing bearing seal with the housing bore and install the seal.
Item 6: Rear Halfshaft Assembly Installation Note
