Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
9. Set the halfshaft assembled length to specifications.
1
Measure the entire assembly length.
2
Push in or pull out on the inner joint as necessary to adjust the halfshaft assembled length.
3
Hold the inner joint to prevent the assembled length from changing, and insert a small flat-blade screwdriver between the boot and the joint to
equalize the pressure.
10. Using the special tool, install both boot clamps.
Item 2: Rear Axle Wheel Hub Retainer and Washer Installation Note
1. CAUTION: Never use power tools to tighten the rear axle wheel hub retainer.
Install a new rear axle wheel hub retainer and washer.