Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
2.
Remove the bolt and disconnect the wheel speed sensor (Figure 2). To install, tighten to 71 lb-in (8 N.m).
3.
Remove the parking brake shoes. For additional information, refer to Workshop Manual, Section 206-05.
4.
Remove and discard the toe link-to-wheel knuckle nut. To install, tighten to 66 lb-ft (90 N.m).
CAUTION
DO NOT DAMAGE THE BOOT WHILE SEPARATING THE TOE LINK FROM THE WHEEL KNUCKLE.
5.
Remove the bolt and separate the toe link from the wheel knuckle.
6.
Remove and discard the upper arm-to-wheel knuckle nut. To install, tighten to 66 lb-ft (90 N.m).
CAUTION
DO NOT DAMAGE THE BOOT WHILE SEPARATING THE BALL JOINT FROM THE WHEEL KNUCKLE.
7.
Remove the bolt and separate the upper arm from the wheel knuckle.
8.
Using the Special Tool 205-D070 (D93P-1175-B), or equivalent, press the outboard CV joint until it is loose from the hub (Figure 3).
9.
Remove and discard the lower arm-to-wheel knuckle nut. To install, tighten to 111 lb-ft (150 N.m).
10.
Remove the lower arm-to-wheel knuckle bolt.
11.
Remove the wheel knuckle.
