Mountaineer AWD V6-4.0L VIN K Flex Fuel (2003)
2. Remove the components in the order indicated in the illustration and table.
To remove individual components, only carry out the listed steps.
3. To install, reverse the removal procedure.
Item 4: Rear Door Glass-To-Regulator Bolts Removal Note
CAUTION: Make sure the hole in the glass bracket do not become enlarged during the rivet removal process. If the hole become enlarged,
the new rivets may become loose, resulting in a clicking noise concern.
NOTE: Some vehicles may use rivets to attach the glass to the regulator.
NOTE: Use a 4.5 mm (0.1772 in) drill bit to drill out the glass-to-regulator rivets.
1. Lower the rear door window glass as necessary to access the bolts or rivets.
2. If removing the rear door glass regulator assembly and motor, secure the rear door glass in the full up position with tape.
3. If removing the rear door glass regulator assembly and motor, remove the inside door handle but do not disconnect the latch cable.
1
Remove the screw.
2
Disengage the inside door handle from the door.
Item 5: Rear Door Window Glass Removal Note
