Mountaineer AWD V8-4.6L (2010)
11. Remove and discard the side shield from the seat cushion frame. See Figure 5.
1. Pull outward on the middle and the rear of the side shield Carefully release the side airbag module wire harness locator from the side shield.
2
Using a suitable tool, remove and discard any remaining side shield retainers from the seat cushion frame.
3
If equipped with a power seat, disconnect the seat control switch electrical connector Remove the seat control switch from the side shield.
12
Pull the seat cushion trim cover in toward the center of the seat and twist rearward to release the trim cover retaining pocket from the metal tab of
the RH recliner Separate the hook-and-loop from the safety belt buckle. See Figure 6.
13. NOTE: For proper routing during assembly note the routing of the side air bag module wire harness and the pin-type retainers.
