Mountaineer AWD V8-4.6L (2010)
Using a 1/8 in. (3 mm) punch, carefully remove the rivet bodies from the manual lumbar control/seat cushion frame. See Figure 9.
16. Disconnect the manual lumbar control from the cable. See Figure 10.
17. Using a low speed drill with a 11/64 in (4.37 mm) drill bit, enlarge the manual lumbar control rivet holes for the installation of the new rivets.
18. NOTE: For proper routing during assembly, note the routing of the manual lumbar cable and the pin-type retainers.
Release and discard the manual lumbar cable pin-type retainers from the seat cushion frame.
All Seats
19. Remove and discard the four recliner-to-seat cushion frame bolts and separate the seat backrest from the seat cushion frame. See Figure 11.
