Mountaineer AWD V8-4.6L (2010)
3. Roll the backrest trim cover down and attach the hook-and-loop strips.
34. NOTE: When installing the new first row hog rings, position the hog ring on the listing wire first. Install the new first row hog rings.
1. Using suitable hog ring pliers, install the new first row hog rings onto the listing wire.
2. Attach the hook-and-loop strips and the backrest trim cover lower J-clip.
35. Attach the backrest trim cover to the inboard and outboard recliners with two new push pins.
36. NOTICE: The RH and LH head restraint guide sleeves are not interchangeable Failure to correctly install the head restraint guide sleeves may
result in component failure.
Install the new head restraint guide sleeve with the large button and wide key on the LH side of the seat with the button facing the driver door. See
Figure 21.
NOTE:
LH large button head restraint guide sleeve shown, RH small button guide similar.
37. Install the new head restraint guide sleeve with the small button and thin key on the RH side of the seat with the button facing the driver door. See
Figure 21.
38. To install the head restraint guide sleeves, slide the sleeves through the backrest trim cover and the foam pad Using back and forth motion while
twisting, apply downward pressure until the sleeve is seated onto the backrest frame as far as it will go See Figure 22.
