Mountaineer AWD V8-4.6L (2010)
passenger seat that is not secured in the vehicle may result in damaged seat components Failure to follow these instructions may result in incorrect
operation of the occupant classification sensor (OCS) system and increases the risk of serious personal injury or death in a crash.
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition switch is ON
Removal
NOTE:
Driver seat shown unless otherwise noted
1. Depower the Supplemental Restraint System (SRS) For additional information, refer to the WSM, Section 501 20B, SRS Depowering Procedure
2. NOTE: If the metal retaining clip remains on the seat cushion frame, transfer the clip to the cover Using a suitable trim tool, remove the safety belt
anchor bolt cover by lifting outward and upward. See Figure 1.
3. Remove the safety belt anchor bolt and separate the anchor from the seat.
4. Remove the seat track-to-floor bolt front cover.
1. The seat track must be back far enough for the rear of the cover to slide up and the locator tab to separate from the seat track.
2. Pull up at the front to release the clips, then slide up and forward to remove.
5. NOTE: If equipped with power seats, move the seat to its highest vertical position.
