Mountaineer AWD V8-4.6L (2010)
12. Remove the side shield from the seat cushion frame. See Figure 7.
1. Release the side shield front clip by pulling the front of the side shield outward from the seat cushion frame.
2. Release the two bottom retainers by pulling outward on the side of the shield. Lift up to detach the upper hooks.
3. Using a suitable trim tool, remove and discard the side shield rear pin4ype retainer.
4. If equipped with a power seat disconnect the seat control switch electrical connector.
13. Pull the seat cushion trim cover in toward the center of the seat and twist rearward to release the trim cover retaining pocket from the metal tab of
the recliner. See Figure 8.
