Mountaineer AWD V8-4.6L (2010)
Parking Brake Cable: Removal and Replacement
Parking Brake Cable - Rear, LH
Parking Brake Cable - Rear, LH
Removal and Installation
1. Release the parking brake cable tension. For additional information, refer to Parking Brake Cable Tension Release See: Procedures.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Remove the wire form bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
4. Remove the bracket bolt.
-
To install, tighten to 23 Nm (17 lb-ft).
5. Disconnect the intermediate cable from the LH rear cable at the cable equalizer.
6. Disconnect the front of the LH rear cable conduit at the frame bracket.
7. Disconnect the LH parking brake cable from the parking brake lever and remove the cable.
8. To install, reverse the removal procedure.
-
Test the parking brake system for correct operation.
Parking Brake Cable - Rear, RH
