Mountaineer AWD V8-4.6L (2010)
8. NOTICE: The crankshaft cannot be moved once set or engine damage may occur.
Rotate the crankshaft a half turn clockwise, as viewed from the front, positioning the No. 5 cylinder camshaft exhaust lobe at the 11 o'clock
position as shown.
9. NOTICE: Engine is not freewheeling. Camshaft procedure must be followed exactly or damage to valves and pistons will result.
NOTE: The Timing Chain Locking Tool must be installed square to the timing chain and the engine block.
NOTE: Engine front cover removed from art for clarity.
Install the Timing Chain Locking Tool in the LH timing chain as shown.
10. NOTICE: Do not remove the Timing Chain Locking Tool at any time during assembly. If the Timing Chain Locking Tool is removed or
out of placement, the engine front cover must be removed and the engine must be retimed. For additional information, refer to Timing
Drive Components See: Timing Components/Service and Repair/Removal and Replacement. Failure to follow this instruction can result
in damage to the valves and pistons.
NOTICE: The timing chain must be installed in its original position onto the camshaft phaser and sprocket using the scribed marks, or
damage to valves and pistons will result.
NOTE: RH shown, LH similar.
