Mountaineer AWD V8-4.6L (2010)
Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the drain plug and drain the engine oil.
-
To install, tighten to 23 Nm (17 lb-ft).
3. Remove the cooling fan shroud. For additional information, refer to Cooling System &/or Engine Block Heater.
4. Remove the RH side idler pulley. For additional information, refer to Drive Belts, Mounts, Brackets and Accessories.
5. Remove the RH valve cover. For additional information, refer to Valve Cover - RH See: Cylinder Head Assembly/Valve Cover/Service and
Repair/Valve Cover - RH.
6. Remove the LH valve cover. For additional information, refer to Valve Cover - LH See: Cylinder Head Assembly/Valve Cover/Service and
