Mountaineer AWD V8-4.6L (2010)
Removal and Installation
1. Remove the center instrument panel finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Remove the shield screw.
3. Remove the shield.
4. Lower the glove compartment.
5. Disconnect the floor door vacuum control motor vacuum connector.
6. Detach the instrument panel harness pin-type retainer and position the harness aside.
7. Remove the 2 floor door vacuum control motor screws.
8. Remove the RH floor console finish panel.
9. NOTE: The retaining arm must be slightly deflected away from the vacuum control motor arm to provide clearance.
Partially actuate and rotate the floor door vacuum control motor until it clears the retaining arm and remove the vacuum control motor.
