Mountaineer AWD V8-4.6L (2010)
10. To install, reverse the removal procedure.
Vacuum Control Motor - Panel Door
Vacuum Control Motor - Panel Door
Removal and Installation
1. Remove the Audio Control Module (ACM). For additional information, refer to Accessories and Optional Equipment.
2. Lower the glove compartment.
3. Remove the 3 center panel duct screws and position the center panel duct aside.
4. Remove the 2 plenum chamber screws.
5. Disconnect the panel door vacuum control motor vacuum connector.
6. Remove the 2 panel door vacuum control motor screws.
7. NOTE: The plenum chamber must be slightly repositioned to allow the panel door vacuum control motor to be rotated far enough to clear the
retaining arm.
