Mountaineer AWD V8-4.6L (2010)
7. Disconnect the auxiliary temperature blend door actuator electrical connector.
8. Remove the 3 auxiliary temperature blend door actuator screws.
9. Remove the auxiliary temperature blend door actuator.
10. To install, reverse the removal procedure.
Vacuum Control Motor - Air Inlet Door
Vacuum Control Motor - Air Inlet Door
Removal and Installation
1. Lower the glove compartment.
2. Remove the screws and the heater core and evaporator core housing support brace.
3. Disconnect the air inlet door vacuum control motor vacuum connector.
4. Remove the 2 air inlet door vacuum control motor screws.
5. Rotate the air inlet door vacuum control motor until it clears the retaining arm and remove the vacuum control motor.
6. To install, reverse the removal procedure.
