Mountaineer AWD V8-4.6L (2010)
7. Remove the 2 driver air bag module bolts (1 shown).
8. Disconnect the 3 driver air bag module electrical connectors and remove the driver air bag module.
9. Open and lower the glove compartment door.
10. Detach the wiring retainer, remove the 4 bolts and passenger air bag module heat shield.
11. NOTE: The canister vent and adaptive tether do not require deactivation.
Disconnect the LH side passenger air bag module electrical connector.
12. Under the rear of the passenger seat, detach the passenger seat side air bag module electrical connector from the seat track bracket. Disengage the
passenger seat side air bag module electrical connector locking clip, release the tab and disconnect the passenger seat side air bag module
electrical connector.
Explorer and Mountaineer vehicles
13. Release and position aside the passenger side C-pillar trim panel.
