mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 8573 > < Initial Inspection and Diagnostic Overview|Page 8571
Page 10
background image

Yes

INSTALL a new SJB. REFER to Body Control Systems. TEST the system for normal operation.

No

The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the
self-test.

-------------------------------------------------

Pinpoint Test AA: The Trailer RH Stop/Turn Lamp Is Inoperative

Trailer Lamps

Pinpoint Tests

Pinpoint Test AA: The Trailer RH Stop/Turn Lamp Is Inoperative

Refer to Wiring Diagram Set 95, Trailer/Camper Adapter for schematic and connector information.  See: Diagrams/Electrical Diagrams/Diagrams By
Number

Normal Operation

Voltage to the RH trailer stop/turn lamp is supplied by the Smart Junction Box (SJB) to the trailer tow connector for the RH trailer stop/turn lamp.

-

DTC B2070 (Trailer Tow Relay Coil(s) Circuit Failure) - a continuous DTC that sets when the SJB detects a short to ground from the RH trailer
stop/turn lamp voltage supply circuit. The self-test must be run after the repair in order for the SJB to enable the output for the RH trailer stop/turn
lamp voltage supply. A trailer equipped with too many RH stop/turn bulbs may also set the DTC.

This pinpoint test is intended to diagnose the following:

-

Trailer equipped with too many bulbs

-

Wiring, terminals or connectors

-

Trailer tow connector

-

Trailer

-

SJB

PINPOINT TEST AA: THE TRAILER RH STOP/TURN LAMP IS INOPERATIVE

NOTICE:  Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.

NOTE:  Before beginning diagnostics, visually inspect the trailer tow connector for signs of corrosion or damage. Repair or install a new trailer tow
connector as required.

-------------------------------------------------
AA1 CHECK THE RECORDED DTCs FROM THE SJB SELF-TEST

-

Check the recorded results from the SJB self-test.

-

Was DTC B2070 present?

Yes

GO to AA2.

No

GO to AA6.

-------------------------------------------------
AA2 CLEAR THE DTCs AND REPEAT THE ON-DEMAND SELF-TEST WITH THE TRAILER DISCONNECTED

-

Disconnect the trailer from the vehicle.

Initial Inspection and Diagnostic Overview|Page 8573 > < Initial Inspection and Diagnostic Overview|Page 8571