Mountaineer AWD V8-4.6L (2010)
6. Connect the Transporter Fluid Evacuator/Injector.
-
Connect the open end of the fluid hose from the Transporter Fluid Evacuator/Injector to the Transmission Fluid Fill Tool at the bottom of the
transmission fluid pan.
7. Apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the Rubber Tip Air Nozzle. Transmission fluid will
immediately start flowing out of the Transporter Fluid Evacuator/Injector into the transmission fluid pan.
8. Add 1.89L or 2.83L (2 qt or 3 qt) of transmission fluid into the transmission fluid pan. Stop the process by releasing the air pressure and removing
the Rubber Tip Air Nozzle from the end of the hose.
9. NOTE: Engine idle speed is approximately 650 rpm.
Using the scan tool, start and run the engine until the Transmission Fluid Temperature (TFT) is between 27°C-49°C (80°F-120°F).
10. Inspect the transmission fluid level in the Transporter Fluid Evacuator/Injector. If the fluid drains back into the canister, the transmission is full. If
no transmission fluid drains back, more transmission fluid will need to be added.
11. Once the transmission is full, place a hand Vacuum Pump Kit on the open end of the vacuum/pressure hose on the Transporter Fluid
Evacuator/Injector and apply vacuum to the system. This will pull out any extra fluid trapped in the system and direct it into the container.
12. Allow the transmission fluid to drain. When the transmission fluid comes out as a thin stream or drip, the transmission fluid is at the correct level.
13. Reinstall the small (center) transmission fluid level indicator plug.
