Mountaineer AWD V8-4.6L (2010)
Disconnect the ground wire and remove the screw and lift up to remove the fuel level sender.
Installation
1. Route the fuel level sender ground wire along the FP body.
2. Route the fuel level sender wire through the center of the FP.
3. NOTE: Both fuel gauge sending wires must be routed behind the metal sending unit plate.
Hook the fuel level sender on the FP and install and tighten the screw. Connect the fuel level sender unit ground wire.
4. Slide the heat shrink tube onto the wire harness and connect the fuel level sender wire electrical connector.
5. WARNING: Do not use an open flame to shrink the heat shrink tube. Use a heat gun only. Fuel residue may be ignited if an open flame is
used. Failure to follow this instruction may result in serious personal injury.
Using a heat gun, shrink the heat shrink tube.