Mountaineer AWD V8-4.6L (2010)
4. Remove the front driveshaft from the vehicle.
All vehicles
5. Remove the selector lever cable shield by prying on the side of the selector lever cable shield closest to the Transmission Range (TR) sensor
connector boot, then sliding the selector lever cable shield away from the TR sensor connector boot.
6. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
Remove the selector lever cable and selector lever cable bracket.
7. Disconnect the Turbine Shaft Speed (TSS) sensor connector.
8. Remove the TSS sensor.
1. Remove the TSS sensor screw.
2. Remove the TSS sensor from the transmission.
-
Inspect the TSS sensor O-ring for damage. If damaged, install a new O-ring.
