mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

Air Bag Trim Cover - Passenger|Page 5857 > < Air Bag Trim Cover - Passenger|Page 5855
Page 2
background image

may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

NOTE:  The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE:  The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

All vehicles

1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  See: Air Bag(s)

Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.

2. Remove the headliner.

Vehicles with auxiliary climate control

3. Remove the 2 retainers and auxiliary climate control headliner duct from the C-pillar.

All vehicles

4. NOTE: Note the Safety Canopy(R) module wiring harness routing for installation.

Disconnect the Safety Canopy(R) module electrical connector and detach the connector and wiring pin-type retainers from the C-pillar.

Vehicles with moon roof

5. NOTE: Note the position of the 2 rear moon roof drain hose routing clips for installation.

Disconnect the rear moon roof drain tube and detach the 2 rear moon roof drain hose routing clips.

Vehicles with entertainment system

6. NOTE: Note the position and routing of the entertainment system wiring for installation.

Detach the 2 entertainment system wiring retainers and position wiring aside.

All vehicles

7. NOTE: Note the locator tab on the front tether anchor bracket to the A-pillar sheet metal for installation.

Remove the bolt and front tether anchor bracket.

Air Bag Trim Cover - Passenger|Page 5857 > < Air Bag Trim Cover - Passenger|Page 5855