Mountaineer AWD V8-4.6L (2010)
NOTE: Make sure the C-pillar and side impact severity sensor mating surfaces are clean and free of foreign material.
Remove the 2 bolts and side impact sensor.
-
To install, tighten to 12 Nm (106 lb-in).
8. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque.
Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
9. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag(s)
Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures.
