Mountaineer AWD V8-4.6L (2010)
7. NOTE: Note the locator tab position where the OCS rail goes through the rail shield and into the rear seat track mounting point for installation.
Remove the 2 front bolts and OCS rail and shield.
Installation
NOTE: If installing a new seat track, position the seat track where the seat will be in the full rearward position before installing the OCS rails.
NOTE: To make sure of correct installation, the OCS rail bolts must be installed in the sequence shown.
1. WARNING: To prevent foreign material and contaminants from entering the occupant classification sensor (OCS) rail, make sure the
OCS rail shield is present, is not damaged and is correctly installed to the OCS rail. Failure to follow these instructions may result in
incorrect operation of the OCS system and increases the risk of serious personal injury or death in a crash.
NOTICE: Prevent oil and/or grease from getting on the Occupant Classification Sensor (OCS) rail bolts as this can lead to tightening
beyond the specified torque value. Failure to follow this instruction may result in damaged or broken OCS rail bolts.
NOTE: Make sure the OCS rail shield is seated correctly on the OCS rail.
Install the shield on the OCS rail, and install the OCS rail and shield on the seat track with the locator tab aligned correctly as shown.
2. Hold the OCS rail and shield firmly in position and install the front mounting position rear bolt.
-
Tighten to 25 Nm (18 lb-ft).
3. Hold the OCS rail and shield firmly in position and install the front mounting position front bolt.
-
Tighten to 25 Nm (18 lb-ft).
4. Move the seat to the forward stop position.
-
If equipped with a power seat track, apply power and ground to the pins shown.
