Mountaineer AWD V8-4.6L (2010)
Removal and Installation
1. Disconnect the battery. For additional information, refer to Battery Disconnect See: Service and Repair/Battery Disconnect.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
3. Remove the nut and position the battery cable body ground terminal aside.
-
To install, tighten to 9 Nm (80 lb-in).
4. Disconnect the battery cable electrical connector.
5. Remove the 2 battery cable locators from the battery tray.
6. Remove the Battery Junction Box (BJB) terminal nuts.
-
To install, tighten to 9 Nm (80 lb-in).
7. Position the generator harness terminal aside.
8. Position the BJB terminal aside.
9. Remove the 2 nuts and position the battery cable bracket aside.
-
To install, tighten to 20 Nm (177 lb-in).
10. Remove the nut and position the power steering line bracket aside.
-
To install, tighten to 12 Nm (106 lb-in).
11. Remove the nut and position the battery cable engine front cover bracket aside.
-
To install, tighten to 10 Nm (89 lb-in).