Mountaineer AWD V8-4.6L (2010)
-
Discard the bolts.
-
To install, tighten the new bolts to 55 Nm (41 lb-ft) at curb height.
6. NOTICE: The LH and RH side stabilizer bar bushings are different and are not interchangeable. Make sure the bushings are installed
on the correct side or damage to the bushings will occur.
NOTE: When installing the LH side sway bar bushings onto the sway bar, match the groove in the bushing to the upset on the sway bar.
NOTE: Inspect the stabilizer bar bushings for wear or damage. Install new bushings as necessary.
NOTE: Tighten LH side first.
Remove the 2 stabilizer bar bushings.
7. To install, reverse the removal procedure.
Four Wheel Drive (4WD)
Stabilizer Bar and Link
Removal and Installation
For additional information, refer to Rear Wheel Drive (RWD). See: Rear Wheel Drive (RWD)
