Mountaineer AWD V8-4.6L (2010)
2. Connect the fuel filler pipe tube-to-fuel sensor line.
3. Connect the fuel filler pipe tube-to-fuel pressure sensor line quick connect coupling.
4. Install the 4 stabilizer bar bracket studs.
5. Install the 2 stabilizer bar bushings and the 2 stabilizer bar brackets.
6. Install the 4 new stabilizer bar bracket nuts.
-
Tighten to 48 Nm (35 lb-ft).
7. Using the jack, raise the suspension until the distance between the center of the hub and the lip of the fender is equal to the measurement taken in
Step 1 (curb height) in Removal.
8. Install the stabilizer bar link and new link nut and grommet.
-
Tighten the nut to 30 Nm (22 lb-ft).
9. NOTICE: The upper arm outboard bolts must be installed with the bolt head toward the front of the vehicle or wheel damage may occur.
Install the 2 new upper arm outboard bolts and the 2 new upper arm outboard nuts.
-
Tighten to 225 Nm (166 lb-ft).
10. Remove the jack.
11. Install the wheel and tire. For additional information, refer to Wheels and Tires.