Mountaineer AWD V8-4.6L (2010)
1. Using the scan tool, monitor the Transmission Fluid Temperature (TFT).
2. Start the engine.
3. NOTE: Engine idle speed is approximately 650 rpm.
Run the engine until the TFT is between 27-49°C (80-120°F).
4. Move the selector lever slowly through each gear, stopping in each position and allowing the transmission to engage.
5. Place the selector lever in the PARK position.
6. With the engine running and the vehicle set as close to level as possible, position it on a hoist. For additional information, refer to Vehicle Jacking
and Lifting.
7. Hold the larger transmission fluid drain plug with a wrench and remove the small (center) transmission fluid level indicating plug.
8. Install the Transmission Fluid Fill Tool into the pan.
9. NOTE: Prior to filling the Transporter Fluid Evacuator/Injector with transmission fluid, make sure that the canister is clean.
Fill the Transporter Fluid Evacuator/Injector with transmission fluid.
