Mountaineer AWD V8-4.6L (2010)
2. Fill the Transporter Fluid Evacuator/Injector with approximately 0.47L (1 pt) of transmission fluid.
3. Hang the Transporter Fluid Evacuator/Injector under the vehicle, upright and close to the transmission.
4. Connect the Transporter Fluid Evacuator/Injector and Transmission Fluid Fill Tube.
-
Connect the open end of the fluid hose from the Transporter Fluid Evacuator/Injector onto the Transmission Fluid Fill Tube from the
transmission case.
5. Use a Rubber Tip Air Nozzle to apply a maximum of 206.85 kPa (30 psi) to the open end of the vacuum/pressure hose from the Transporter Fluid
Evacuator/Injector. Transmission fluid will immediately start flowing out of the Transporter Fluid Evacuator/Injector into the transmission.
6. NOTE: Do not overfill the transmission. The transmission fluid level must be at the upper level of the crosshatch mark.
Reinstall the transmission fluid level indicator only back into the transmission fluid fill plug hole to check the transmission fluid level. Repeat this
until a consistent reading is established.
