Mountaineer AWD V8-4.6L (2010)
reused.
Install the transmission fluid pan gasket on the transmission fluid pan.
11. Install the transmission fluid pan and transmission fluid pan gasket and loosely install the transmission fluid pan-to-case screws.
12. Tighten the transmission fluid pan-to-case screws in a crisscross sequence.
-
Tighten to 11 Nm (97 lb-in).
13. NOTICE: Damage will occur to the transmission vehicle harness connector if the screw is tightened above specification.
NOTE: Always install new O-ring seals on the transmission control solenoid body connector.
NOTE: Clean the area around the transmission vehicle harness connector to prevent contamination of the transmission control solenoid body
connector.
NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.
Install and lubricate new O-ring seals on the transmission control solenoid body harness connector and connect the connector.
-
Tighten to 5 Nm (44 lb-in).
14. Fill the transmission. For additional information, refer to Transmission Fluid Drain and Refill See: Service and
Repair/Procedures/5R55S/Transmission Fluid Drain and Refill.
Solenoid Body Assembly
Solenoid Body Assembly
