Mountaineer AWD V8-4.6L (2010)
6. NOTICE: Damage will occur to the transmission vehicle harness connector if the screw is tightened above specification.
NOTE: Always install new O-ring seals on transmission control solenoid body harness connector.
NOTE: Clean the area around the transmission vehicle harness connector to prevent contamination of the transmission control solenoid body
connector.
NOTE: Use petroleum jelly to lubricate the O-ring seals to aid in the installation process.
Install and lubricate new O-ring seals on the transmission control solenoid body harness connector and connect the connector.
-
Tighten to 5 Nm (44 lb-in).
7. Fill the transmission. For additional information, refer to Transmission Fluid Level Check See: Service and
Repair/Procedures/5R55S/Transmission Fluid Level Check.
6R80
Mechatronic Assembly
Removal
Mechatronic assembly
NOTICE: The only solenoid that is serviceable in the mechatronic assembly is Shift Solenoid E (SSE). If the mechatronic assembly is being
removed due to a faulty SSE, follow the specific steps in this procedure to install a new SSE. If the mechatronic assembly is being removed due
to a faulty solenoid other than SSE, a new mechatronic assembly must be installed.
NOTE: If a new or existing mechatronic assembly is installed, the Transmission Control Module (TCM) will need to be programed with the latest
calibration.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. NOTICE: Do not pull on the wire harness to disconnect the connector or damage to the connector will occur.
Disconnect the transmission vehicle harness connector by twisting the outer shell and pulling back on the connector.
3. Remove the transmission fluid fill plug transmission fluid level indicator assembly located on the passenger side front portion of the transmission
case. Removal of the transmission fluid fill plug will relieve any vacuum that might have built up in the transmission. This will aid in allowing the