mercury Workshop Repair Guides

Mercury Workshop Service and Repair Manuals

A/T - Fluid Leaks From Bulkhead Connector|Page 4001 > < Removal and Replacement|Page 3992
Page 1
background image

Wiring Harness: All Technical Service Bulletins
A/T - Fluid Leaks From Bulkhead Connector

TSB 11-3-25

03/31/11

6R80 TRANSMISSION BULKHEAD CONNECTOR 
SLEEVE LEAKING TRANSMISSION FLUID

FORD:
2009-2010 Expedition, Explorer Sport Trac, 
Explorer, F-150

LINCOLN:
2009-2010 Navigator

MERCURY:
2009-2010 Mountaineer

ISSUE
Some 2009-2010 F-150, Expedition, Explorer Sport Trac, Explorer, Mountaineer and Navigator vehicles equipped with a 6R80 transmission may show
signs of transmission fluid leakage around the transmission bulkhead connector sleeve.

ACTION
Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

Verify the leak is present at the transmission bulkhead connector sleeve. With the vehicle in neutral, position it on a hoist. For additional information,
refer to Workshop Manual (WSM), Section 100-02.

1. Disconnect the transmission vehicle harness connector by twisting the outer shell and pulling back on the connector.

2. Remove the transmission fluid pan and allow the transmission fluid to drain.

3. Pull the release tab and pull down on the transmission bulkhead electrical connector retainer.

4. With the release tab down, pull the connector sleeve out of the case/mechatronic assembly.

5. Lube new connector sleeve 0-rings with clean transmission fluid, then install connector sleeve into case/mechantronic assembly.

6. Press up on the tab and lock the outer shell of the transmission bulkhead electrical connector sleeve in place. Make sure that the locking tab is

securely locked.

7. Install the transmission fluid pan/gasket and refill transmission fluid refer to WSM, Section 307-01 for refill procedure.

NOTE

DO NOT TOUCH THE ELECTRICAL CONNECTOR PINS OR THE EXPOSED SOLENOID TABS ON THE TRANSMISSION BULKHEAD
ELECTRICAL CONNECTOR. ELECTROSTATIC DISCHARGE MAY OCCUR AND MAY CAUSE DAMAGE TO THE TRANSMISSION
CONTROL MODULE (TCM).

NOTE

BULKHEAD CONNECTOR SLEEVES MAY COME WITH RED OR BLACK 0-RING SEALS. USE ONLY BULKHEAD CONNECTOR
SLEEVE THAT HAS BLACK 0-RING SEAL FOR THIS PROCEDURE.

Parts Block

WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage 
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.

A/T - Fluid Leaks From Bulkhead Connector|Page 4001 > < Removal and Replacement|Page 3992