Mountaineer AWD V8-4.6L (2010)
1. Pack the outboard CV joint with grease from the kit.
-
One-third of the grease must be installed in the joint with the remainder placed in the boot.
2. Spread the remaining grease evenly inside the boot.
2. Position the boot so the rib on the boot is located in the groove of the shaft.
3. Position the outboard halfshaft boot and the outboard boot clamps.
1. Position the boot.
2. Position the 2 boot clamps.
4. Using the Constant Velocity Joint Boot Clamp Installer, install the outboard CV boot clamps.
5. Position the inboard clamp and boot.
6. Install the CV joint and snap ring on the halfshaft.
