Mountaineer AWD V8-4.6L (2010)
2. Remove and discard the halfshaft nut.
-
To install, tighten the new nut to 250 Nm (184 lb-ft).
3. Using the Front Wheel Hub Remover, separate the outboard CV joint from the wheel hub.
4. NOTICE: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.
Remove the bolts and position the caliper, pads and anchor plate assembly aside.
-
Discard the bolts.
-
Support the caliper and anchor plate assembly using mechanic's wire.
-
To install, tighten the new bolts to 165 Nm (122 lb-ft).
5. Remove the brake disc.
6. NOTE: A new wheel bearing and wheel hub comes with the wheel speed sensor installed.
Disconnect the wheel speed sensor harness electrical connector and remove and discard the wheel speed sensor harness bracket bolt.
-
To install, tighten to 8 Nm (71 lb-in).
7. Remove the 3 bolts and the wheel bearing and hub assembly.
-
Discard the bolts.
-
To install, tighten the new bolts to 122 Nm (90 lb-ft).
8. To install, reverse the removal procedure.
