Mountaineer AWD V8-4.6L (2010)
Installation
All vehicles
1. Inspect the TSS O-ring seal for damage. Install a new O-ring seal if damaged. Lubricate the O-ring seal with petroleum jelly to prevent damage to
the O-ring seal.
1. Install the TSS sensor into the transmission.
2. Tighten the TSS sensor screw.
-
Tighten to 14 Nm (124 lb-in).
2. Connect the TSS sensor connector.
3. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable to make sure that the selector cable end is correctly installed onto the manual control lever.
Install the selector lever cable end onto the manual control lever, selector lever bracket and selector lever bracket screws.
-
Tighten to 40 Nm (30 lb-ft).
4. NOTE: If the selector lever cable shield is loose on the selector lever cable, install a new shield.
Install the selector lever cable shield.