Mountaineer AWD V8-4.6L SOHC VIN W (2002)
Refer to the garage door opener instruction manual.
3
Press the training button on the garage door opener receiver for 1 - 2 seconds.
4
Press the programmed universal transmitter button for as long as the universal transmitter red light flashes (1 - 2 seconds). Release the button
and re-press the button to confirm that the universal transmitter is trained to the receiver.
5
The garage door opener should recognize the universal transmitter.
Erasing Channels
1. To erase all three programmed channels, hold down the two outside buttons until the red light begins to flash (20 - 30 seconds). Release both
buttons.
NOTE: Individual channels cannot be erased, but can be reprogrammed using the procedures for programming.